13.9. Removal and installation of a slip and the bearing beam of bumpers
Front bumper
Models to 02.1997 g of release
|
- Turn out two bolts (1) about an air inlet.
Bolts of fastening of an overlay of a front bumper
- Turn out from below three bolts (2) from a frontal beam of a body.
- Turn out four bolts (3) from loker of wheel arches.
- Give two nuts (4) from overlays of a wheel arch.
- On the cars equipped with washers of lenses of headlights disconnect hoses from snuffled.
- On the cars equipped with fog lights separate their sockets.
- Take away overlays of wheel arches from wings and, by means of the assistant, remove an overlay of a front bumper.
- Disconnect a cable (1) from the bearing beam and turn out bolts of its fastening (2) On the Tigra model previously disconnect shock-absorbers of a front bumper from the bearing beam.
Fastening of a cable (1) and the bearing beam (2)
- Install the being removed components as it should be, the return to a removal order.
- If you establish washers of lenses of headlights on the Corsa and Combo models, drill adjusting openings according to the sizes given on an accompanying illustration. Establish nozzles and connect to them hoses.
Adjusting sizes of a washer of lenses of headlights
- Join shtekerny connection of a fog light if it is available, fix the plug.
|
|
Models from 03.1997 g of release
The overlay of a front bumper and decorative front grille are removed separately.
Bolts of fastening of an overlay of a front bumper
Rear bumper (Corsa and Tigra models)
|
- Remove the lighting lamp of registration plate (see the Head Onboard electric equipment).
- Remove an overlay of a rear bumper. For this purpose give fixture listed on an accompanying illustration. On the Tigra models there are no screws (1), but two screws over registration plate are added.
Elements of fastening of an overlay of a rear bumper of the Corsa model
- Wring out an overlay of a wheel arch and remove.
- If necessary turn out bolts of fastening and remove the bearing beam of a rear bumper On the Tigra model previously remove the shock-absorber of the bearing beam.
Fixture of the bearing beam of a rear bumper
|
|