13:29. Removal and installation of the lock of a door of a back (Corsa and Tigra model)

Corsa models

 PERFORMANCE ORDER

  1. Turn out holders of a lifting cord of a cover of the luggage compartment (arrow) from internal facing.

Holders of a lifting cord

  1. Remove an internal upholstery from clamps.
  2. Disconnect a bar of the drive of the lock (1) from the lock cylinder for this purpose turn a plastic clip and remove it from a bar. Take out a bar from a clip opening.

Bar of the drive of the lock (1) and fixture of the lock (arrow)

  1. Give a key of Torx of T30 lock fixture to a back wall of a door.
  2. Installation is made upside-down.

Tigra models

 PERFORMANCE ORDER

  1. Uncover on the holder of the lock.
  2. Disconnect a lock bar from the cylinder. For this purpose turn a plastic clip and remove it from a bar.
  3. Turn out two bolts of fastening of the lock (5). Details of the 6th p 8 - the lock cylinder drive.

Tigra model back door lock cylinder drive

  1. Insert the lock and connect to draft. Tighten fastening bolts with effort of 20 Nanometers.
  2. Expose a wedge (1) in a cover (9). For this purpose turn out screws (4) and remove a plate (3). Vertical adjustment is made by means of the plates (2) having thickness of 1 and 2 mm respectively.
  3. Slightly fix a wedge that it could move. Several times open and close a back door. At the same time the wedge is established in the longitudinal and cross directions. Open a door and tighten screws (4) with effort of 20 Nanometers.