13:23. Removal and installation of the lock of a door



  1. Remove facing of a door.
  2. Remove a protective film. You watch that the film at the same time did not tear. Stick the torn film or replace.
  3. Turn out bolts of fastening of a back guide of glass and disconnect a rubber sealant.

Screws of fastening of a guide of glass
A — Combo
B — Corsa

  1. Take out a guide down.
  2. Remove draft of the external handle (1), the lock of a door (2) and the internal handle (3) from the cylinder of the lock and the handle of a door. For this purpose turn a plastic clip and disconnect it from a bar. Take out a bar from a clip opening.

Draft of the external handle (1), lock of a door (2) and internal handle (3)

  1. Separate the socket of the central lock.
  2. Unscrew screws of fastening and remove the lock from a door a key of Torx of T40.

Bolts of fastening of the lock

  1. Take out the lock from a door.
  2. If necessary remove э / the motor of the drive of the central lock.
  3. Installation is made upside-down.