- Cock the parking brake, a front of the car and establish to a poddomkratta it on props. Remove the right forward wheel and (at the corresponding complete set) protection of a case.
- Take off a belt of the drive of auxiliary units (see the Head Nastroyki and routine maintenance of the car), - previously apply marking of the direction of its rotation on a tape of a belt.
- Weaken a bolt of fastening of a pulley of a bent shaft, - for the purpose of blocking of a bent shaft from a provorachivaniye ask the assistant to include the highest transfer and against the stop to squeeze out a brake pedal. On models with AT give one of bolts of fastening of the hydrotransformer and attach a driving disk to a transmission dome by means of a steel level of couple suitable, equipped with washers of bolts. If the engine is removed from the car, block a flywheel / a driving disk (see the Section Removal, check of a state and installation of a flywheel / a driving disk).
- Turn out a fixing bolt (do not forget about a washer) and remove a pulley from a pin of a bent shaft, - try not to damage the sensor of provision of a bent shaft (CKP).
|
|