4.4.13. Replacement of epiploons of a bent shaft

Right (from the GRM drive) an epiploon

 PERFORMANCE ORDER

  1. Remove a cogwheel of a bent shaft (see the Section Removal and installation of cogwheels of the GRM drive).
  2. Accurately drill or punch two openings in a rigid face surface of an epiploon. Screw pair of self-tapping screws in openings. Grasp with flat-nose pliers heads of screws and accurately take an epiploon from a landing nest, - try not to damage the case of the oil pump.

Extraction of an old epiploon of a bent shaft

  1. Smooth out contact surfaces of a landing nest and a pin of a shaft, having carefully removed from them an agnail and the tease capable to lead to failure of a new epiploon.
  2. Grease sealing sponges of a new epiploon with pure motive oil and by means of a cylindrical mandrel evenly press an epiploon in a landing nest sponges inside and aflush with the surface of the case.

Landing of a new epiploon

As a mandrel the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter will approach, - track that the mandrel rested only against the rigid region of an epiploon.

  1. Remove traces of oil and establish a cogwheel of a bent shaft (see the Section Removal and installation of cogwheels of the GRM drive).

Left (from a flywheel) an epiploon

 PERFORMANCE ORDER

  1. Remove a flywheel or a driving disk (see the Section Removal, check of a state and installation of a flywheel / a driving disk).
  2. Accurately drill or punch two openings in a rigid face surface of an epiploon. Screw pair of self-tapping screws in openings. Grasp with flat-nose pliers heads of screws and accurately take an epiploon from a landing nest.
  3. Smooth out contact surfaces of a landing nest and a pin of a shaft, having carefully removed from them an agnail and the tease capable to lead to failure of a new epiploon.
  4. Grease sealing sponges of a new epiploon with pure motive oil and by means of a cylindrical mandrel evenly press an epiploon in a landing nest sponges inside and aflush with the surface of the block.

As a mandrel the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter will approach, - track that the mandrel rested only against the rigid region of an epiploon.

  1. Remove traces of oil and establish into place a flywheel / a driving disk (see the Section Removal, check of a state and installation of a flywheel / a driving disk).