14:27. Removal and installation of the cylinder of the lock of ignition and its contact element
Ignition lock cylinder
|
|
- The lock of a steering wheel should not be locked.
- Remove overlays of a steering column.
- Insert the ignition key and turn it in situation II.
|
|
On models from 05.1993 g of the issue establish a key in situation I. Locks of ignition of old and new execution are interchanged. |
- Press the small screw-driver or a wire a lock spring. Take out the lock cylinder with the ignition key.
Pressing of a lock spring
- For installation insert the lock cylinder in situation II (on models from 05.1993 g of the issue - into situation I), having recorded it.
|
|
|
|
If on the car to 05.1993 g of the issue is established the cylinder of the lock of new execution, turn the screw-driver a contact element before installation of the cylinder in situation I. |
Contact element (models to 08.1994 g of the issue)
|
|
- Remove overlays of a steering column.
- Separate the socket of a contact element and turn out two screws located opposite to each other.
Screws of a contact element
- Remove a contact element.
- Installation is made upside-down.
|
|