5.4.4. Removal and installation of drafts of the drive of gates of a heater
Removal
Draft of the drive of the gate of ventilation and obduv of a windshield
|
|
- Remove a pocket under the right part of the dashboard.
- Disconnect draft from a support (1) and the lever (2). Take out draft from a guide (3) on the air distributor case below on the right.
Support (1) and lever (2) drafts
|
|
Draft of the drive of the gate of foot wells
|
|
|
Disconnect draft (1) from the air distributor case below on the right and disconnect it from the lever (2). Take out draft.
Draft (1) and lever of the air distributor (2)
|
|
Drafts of the drive of the gate of air ducts (regulation of temperature)
|
|
- Remove a pocket under the right part of the dashboard.
- Disconnect draft (2) to the right of the case э / the motor of the fan and disconnect an internal cable Disconnect and take out draft from the holder (1) at the left.
Holder (1) and draft (2)
- Installation is made upside-down. Establish drafts in compliance with an illustration.
Cables (1, 2, 4, 5) and socket (3) of the control unit
|
|
|
|
When laying drafts do not bend them with a radius less than 60 mm. |