5.4.5. Removal and installation of the fan of a heater

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove a windshield fairing.
  3. Remove the air filter of a heater.
  4. Turn out 4 screws of fastening (1) of the case of the air filter of a heater and remove the case.

Screws of fastening of the case of the air filter

  1. Install the ventilating gate (1) on a control lever in the mode of fresh air.

Ventilating gates (1) and fixture of a casing of the fan (2 and 3)

  1. Unbend lock pads (2, 3) and remove the right top part of a casing of the fan (address an illustration). Similarly remove the left top part of a casing of the fan.
  2. Insert the screw-driver into a lock spring э / the motor of the fan and release it.

Removal of a lock spring э / heater motor

  1. Separate both sockets of the additional resistor and take out э / the motor.

Installation

 PERFORMANCE ORDER

  1. Check ease of rotation of a krylchatka of the fan in the established state.

If the fan works not at all high-speed modes, then the additional resistor is damaged, as a rule. In this case replace additional resistors in a set.

  1. Installation is made upside-down.