12.2. Forward suspension bracket
Removal and installation of a depreciation rack
Removal
|
|
- Mark the provision of forward wheels in relation to their naves that the balanced wheel could be established in its former situation. Turn out bolts of fastening of wheels at the car standing on the earth. To Poddomkratta a car front, establish it on props and remove forward wheels.
- At the corresponding complete set disconnect an electrical wiring from the ABS sensor.
- Prop up the cross lever of a forward suspension bracket that the power shaft after removal of a depreciation rack did not fall down.
- Turn out bolts of fastening (1) of assembly of the shock-absorber to a rotary fist.
Bolts of fastening of assembly of the shock-absorber to a rotary fist
- Give самоконтрящиеся nuts and remove a set of a depreciation rack with a support down.
Nuts of fastening of a depreciation rack
|
|
Installation
|
|
- Insert a depreciation rack from below and fix it by hand two new самоконтрящимися by nuts with washers.
- Fix assembly of the shock-absorber on a rotary fist. Apply surely new bolts and самоконтрящиеся nuts. Insert bolts behind forward, looking in the direction of the movement of the car. Tighten nuts in four receptions: at first - with effort of 50 Nanometers, then with effort of 90 Nanometers, then tighten nuts on a corner the 45th hail and in conclusion tighten nuts on a corner the 15th hail.
- Tighten both nuts of fastening on a support of a depreciation rack with effort of 30 Nanometers.
- Establish forward wheels so that earlier put tags coincided. Lower the car on the earth and tighten bolts of fastening of wheels with effort of 110 Nanometers.
|
|