7.4.7. Removal and installation of a starter

Assembly of a starter of Valeo

1 — Pruzhina
2 — fastening Screws
3 — the Traction relay
4 — the Lock ring
5 — the Persistent ring
6 — Obgonnaya the coupling with a gear wheel
7 — Э / the motor with a planetary reducer
8 — the Isolating plug
9 — a case Cover
10 — Nuts of fastening of a cover of the case
11 — Isolation of a cover of the case

12 — Pruzhina
13 — the Isolating plates of brushes
14 — the Brush of negative contact
15 — the Brush holder
16 — Consolidation
17 — the Brush of positive contact
18 — the Case
19 — Screws
20 — the Basic plug
21 — the Pin of the bifurcate lever
22 — the Bifurcate lever


The starter is located behind the block of cylinders and is removed down.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. On the diesel engine include RKPP on transfer that it was possible to reach a starter.
  3. Disconnect wires from the plug 30 (1) and the plug 50 (2) on the traction relay.

Plugs of the traction relay

  1. Turn out bolts of fastening (1) from a flange.

Bolts of fastening of a flange

  1. Remove a starter.

Installation

 PERFORMANCE ORDER

  1. On petrol engines establish a starter and tighten bolts of its fastening with effort of 25 Nanometers.
  2. On diesel engines tighten the top bolt of fastening of a starter with effort of 75 Nanometers, and lower - with effort of 45 Nanometers.
  3. Connect wires to plugs 30 and 50 of the traction relay.
  4. Connect a negative wire to the rechargeable battery.

Attach a wire only at the switched-off ignition not to damage ECM.