7.2.6. Removal and installation of the distributor of ignition (C14NZ engine)

The distributor of ignition is given to rotation from the camshaft and is fixed on a head of cylinders from a flywheel.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Mark with a felt-tip pen or a chertilka position of the distributor in relation to a head of cylinders.

Drawing adjusting tags of the distributor

  1. Uncover the distributor and put aside. For this purpose unbend lock brackets sideways at the distributor from a cover by means of the screw-driver.
  2. Separate the multicontact socket of the case of the distributor for what press a wire bracket. At the same time pull for the plug, but not for a cable.
  3. Disconnect a tension level.
  4. Take out the ignition distributor with a tension level from a camshaft bed.
  5. Do not turn a bent shaft at the removed ignition distributor.

Installation

 PERFORMANCE ORDER

  1. Insert the distributor a shaft pin into a camshaft groove.

The pin and groove are located excentricly and can be combined only in one situation.

  1. Fix by hand a tightening level.
  2. If the rotor was removed, check its situation, feats forward and back.
  3. Turn the distributor so that both tags were combined. Tighten fixture of a tightening level. If the distributor is replaced, turn it so that inflow on it (on the right about a groove) was opposite to inflow on the camshaft case.
  4. Clear a distributor cover inside, establish, and record it brackets. Connect the electrical wiring socket.
  5. Check the main control of the moment of ignition (see the Head Nastroyki and routine maintenance of the car).