12.4. Steering

Removal and installation of a steering wheel


The instructions given below belong only to steering wheels without safety cushions. For reasons of safety it is necessary to remove a safety cushion on HUNDRED.


  1. Disconnect a negative wire from the battery.
  2. Establish forward wheels in provision of the rectilinear movement.
  3. Carefully the screw-driver uncover with the horn button.

Removal of a cover of a steering wheel with the horn button

  1. Unbend a lock plate of a nut of fastening of a steering wheel and give a nut.
  2. Mark the provision of a steering wheel of rather steering shaft.
  3. Remove a steering wheel by means of a stripper, for example, of OPEL-KM-210-A.

Removal of a steering wheel

For simplification of removal it is not necessary to knock on a steering shaft and to pull a steering wheel in different directions.

  1. If necessary replace the cable reel in a nave of a steering wheel.

The segment of external lighting on the cable reel in the provision of its installation has to be turned on the left.

Segment of external lighting on the cable reel of a steering wheel

  1. Grease the contact surface of the cable reel with Kontaktfix lubricant or vaseline oil.



  1. Establish into place a steering wheel so that the tags put in advance coincided.
  2. Establish a new lock plate and tighten a nut of fastening of a steering wheel with effort of 25 Nanometers.
  3. Be passed on the car, having checked correctness of installation of a steering wheel.
  4. Record a nut of fastening of a steering wheel a lock plate.
  5. Remove an electrical wiring on a cover of a steering wheel and establish a cover.
  6. Connect a negative wire to the battery and check work of a sound signal.
  7. Check an automatic reset of the switch of external lighting.

The polluted steering wheel can be washed up neutral household solution and warm water.