12.4.5. Removal and installation of the pump GUR

Removal

 PERFORMANCE ORDER

  1. Remove the case of the air filter and a sleeve of an air inlet.
  2. Take off a V-shaped belt (see the Head Nastroyki and routine maintenance of the car).
  3. Disconnect pressure head and returnable hydraulic lines from the pump GUR, in advance having substituted capacity for collecting the following liquid. Zakuporte unions and hoses On an accompanying illustration is shown the diesel engine of 1.5 l.

GUR hydraulic lines

  1. On petrol engines disconnect the pump from the holder and remove it.

Fastening of the pump GUR on petrol models

  1. On the diesel engine of 1.5 l remove a natyazhitel, disconnect the pump and remove it.

On diesel engines for removal of the pump GUR it is necessary to remove a natyazhitel of a driving belt

Installation

 PERFORMANCE ORDER

  1. On the diesel engine of 1.5 l tighten fixture of the holder of the pump to a head of cylinders with effort of 60 Nanometers.
  2. Tighten pump GUR fixture with effort of 30 Nanometers.
  3. Fix a pressure head hose on the pump with effort of 30 Nanometers.
  4. Attach a returnable hose.
  5. Establish a V-shaped belt and pull it (see the Head Nastroyki and routine maintenance of the car).
  6. Install the air filter and a sleeve of an air inlet.
  7. Fill the tank with GUR liquid.
  8. Start the engine and track liquid level in the GUR tank. At lowering of the level at once add liquid, its level should not fall for the lower mark.
  9. Remove air from a hydraulic path of GUR (see the Partition Removal of Air of the hydraulic highway of GUR).