12.3. Back suspension bracket

Removal and installation of the back shock-absorber

Corsa B and Tigra models

Proceeding from a design of a suspension bracket it is only necessary to remove at first one shock-absorber, and then another.

Removal

 PERFORMANCE ORDER

  1. Uncover in facing of salon and give a nut of the protection cover of a dome of the shock-absorber.

Otdavany nuts of the protection cover of a dome of the shock-absorber

  1. Give the top nut of fastening of the shock-absorber, holding its rod a wrench from a provorachivaniye.
  2. Remove a cup of a spring and the rubber shock-absorber.
  3. Car back also establish to Poddomkratta it on props.

The top rubber emphasis can be replaced without removal of all shock-absorber. For this purpose release a support and slightly to a poddomkratta the car.

  1. Give the lower nut of fastening of the shock-absorber.

Lower nut of fastening of the shock-absorber

  1. Remove the shock-absorber.

Installation

 PERFORMANCE ORDER

  1. Check the shock-absorber (see the Section Dismantling, check and assembly of a depreciation rack).
  2. Put on the protection cover and the plug the new shock-absorber.

Components of assembly of the back shock-absorber

1 — the Protection cover
2 — the Nut
3 — the Top cup
4 — the Rubber shock-absorber
5 — the Lower cup

6 — the Rubber emphasis
7 — the Plug
8 — the Hollow buffer
10 — an emphasis Cover
11 — the Shock-absorber

They are not included in the package of delivery of the new shock-absorber.

  1. Enter the shock-absorber from below into a dome.
  2. Install the shock-absorber from below in the holder on consoles of a back axis. If necessary use the plastic hammer.
  3. Level openings in an eye of the shock-absorber and in the holder. Accurately hammer with the plastic hammer against the stop a bolt of fastening of the shock-absorber. Tighten a bolt with effort of 70 Nanometers.
  4. Slowly lower the car, entering at the same time the shock-absorber into a dome.
  5. From the luggage compartment install the rubber buffer and a cup on the shock-absorber and tighten a nut with effort of 20 Nanometers, holding a wrench a shock-absorber rod from a provorachivaniye.
  6. Put on the protection cover of a dome of the shock-absorber.
  7. Insert a cover into facing of salon.

Combo model

 PERFORMANCE ORDER

  1. Car back also establish to Poddomkratta it on props.
  2. By means of a jack unload the back shock-absorber.
  3. Turn out the lower bolt of fastening of the shock-absorber and take out the shock-absorber from the holder.

Otdavany fastenings of the shock-absorber of the lower bolt

  1. Turn off the top bolt of fastening of the shock-absorber and remove the shock-absorber.

Otdavany fastenings of the top bolt

  1. Install the shock-absorber and tighten both bolts of fastening with effort of 70 Nanometers.
  2. Remove a jack and lower the car.