12.2.3. Removal and installation of the stabilizer of cross stability
Removal
|
- Give coupling nuts (1) of collars from the right and left parties of draft and remove the stabilizer.
Coupling nuts of collars of fastening of the stabilizer
|
|
Installation
|
- Oil a rubber support silicone (OPEL No. 90 001 800 or 19 48 454). Replace the damaged rubber support.
- Fix the stabilizer in the area лысок by collars to the left and right drafts and tighten new самоконтрящиеся nuts with effort of 20 Nanometers. Observe at the same time the size A between an internal bolt of draft and the center of a rubber support.
Amount of installation of a collar
|
|
Features of DOHC 1.0 and 1.2 engines of l
|
- You watch the correct position of the stabilizer: the right pin in the provision of installation has to be turned down the Size A designated on an illustration for DOHC 1.0 and 1.2 engines of l has to make 110 mm.
Orientation of the stabilizer at installation
|
|