11:15. Removal and installation of cables of the drive of the parking brake

Mechanism of the parking brake of the Corsa and Tigra models

1 — the Lever of the parking brake
2 — cable Guides
3 — the Short (right) cable

4 — the Compensator
5 — the Long (left) cable
6 — Lengthening with a stopper

Corsa and Tigra models

Right side (short cable)

 PERFORMANCE ORDER

  1. Disconnect the compensator of the parking brake from a brake drive hummock. At the same time hold pincers a carving bar from a provorachivaniye Remove outside the rubber buffer.

Keeping of a carving bar

  1. Remove a cable of the drive of the parking brake from the back suspension bracket directing on a beam.
  2. Take off the right brake boot (see the Section Removal and installation of brake boots).
  3. Take out the plastic plug from a brake board and extend a cable.
  4. Installation is made upside-down.

Left side (long cable)

 PERFORMANCE ORDER

  1. Measure and write down length of a carving of the compensator of a cable of the drive of the parking brake Remove the rubber buffer and turn out the compensator. At the same time hold the compensator a wrench from a provorachivaniye.

Measurement of length of a carving of the compensator

  1. Remove the thermofilter from the muffler.
  2. Exempt a cable of the drive of the parking brake from the extender (shooter) and disconnect it.

Fastening of a cable of the parking brake to the extender

  1. Take out a cable from the holder and guides on a back suspension bracket.
  2. Take off the left brake boot (see the Section Removal and installation of brake boots).
  3. Take out the plastic plug from a brake board and extend a cable.
  4. Installation is made upside-down. You watch that length of a carving of the compensator corresponded to the value which is written down at removal.

Combo model

 PERFORMANCE ORDER

  1. Remove the brake drum (see the Section Removal and installation of brake boots).
  2. Give fixture of system of production of the fulfilled gases around a cable of the drive of the parking brake.
  3. Remove the thermofilter from the bottom.
  4. Give a nut (shooter) of the compensator of the parking brake.

Nut of the compensator of the parking brake

  1. Take out cables from guides.

Extraction of cables from guides

  1. Remove plastic plugs from the holder. Unbend a little directing a cable (shooter) on the bottom and back springs of a suspension bracket and remove a cable.

Plastic plugs

  1. Press the lever of the parking brake on a brake shoe forward and remove a cable.

Removal of a cable

  1. Take out the plastic plug from a brake board and extend a cable.
  2. Establish a cable of the drive of the parking brake in the return sequence and adjust it.