10.2.2. Removal, check and installation of the bearing of switching off of coupling

Removal

 PERFORMANCE ORDER

  1. Remove coupling.
  2. Disconnect a clutch release fork lever from the bearing of switching off of coupling and take out the bearing.

Clutch release fork lever detachment from the bearing

  1. Take out the lever from a coupling basket up.
  2. Remove a clutch release fork lever.
  3. Disconnect a guide of the release bearing from RKPP case.

Bearing guide detachment from RKPP case

  1. Check a sealing ring in a guide of the release bearing for pollution and damage, and, if necessary, replace it. For this purpose the screw-driver take out a sealing ring from a guide of the release bearing.

Check

 PERFORMANCE ORDER

  1. Squeeze the bearing of switching off of coupling and at the same time turn it. If the bearing publishes noise, replace it with new.

Check of the bearing of switching off of coupling

The bearing has long-term lubricant. To clear it and it is not necessary to grease newly.

  1. Check the surfaces of sliding for wear, corrosion and damages.

Installation

 PERFORMANCE ORDER

  1. Grease a new sealing ring between sealing edges lubricant, for example, of OPEL-19 48 524 (90 001 825).
  2. Press a sealing ring on the press by means of the special OPEL KM-445 tool or a short piece of a pipe of suitable diameter.

Installation of a sealing ring

  1. Insert a rubber sealing ring into a groove on RKPP case, without greasing a ring.
  2. Establish a guide of the release bearing on a case of RKPP and fix it with effort of 5 Nanometers.
  3. Grease with a thin layer of lubricant (for example, OPEL 19 48 524 or OPEL 90 001 825) the surfaces of sliding of the release bearing (the coupling switching off bearing) on the directing plug. If necessary, remove the burned lubricant remains.

You do not apply too much lubricant that it did not get on the frictional surfaces of coupling.

  1. Install the coupling switching off lever.
  2. Install the bearing of switching off of coupling on the directing plug and fix a clutch release fork lever on the lever with effort of 35 Nanometers.
  3. Establish coupling.